Repost: CHB_AUTO_CRC_POS

Home Forums Software chibiArduino Repost: CHB_AUTO_CRC_POS

This topic contains 1 reply, has 1 voice, and was last updated by  akiba September 4, 2017 at 5:33 am.

  • Author
    Posts
  • #404

    akiba
    Keymaster

    [This topic reposted from the old forum]
    I noticed while reading the chb_drvr.h header file that this apears that it should have a different value for an AT86RF212, which is what the LR freakduino uses (and which is what I happen to have). Should I set it to value 5? What might be the downside of leaving it as is (which is set to 7)?

    • This topic was modified 2 weeks, 6 days ago by  akiba.
    • This topic was modified 2 weeks, 6 days ago by  akiba.

    Akiba
    FreakLabs Open Source Wireless
    Twitter: @freaklabs
    Facebook: https://www.facebook.com/freaklabswireless

  • #405

    akiba
    Keymaster

    The AT86RF212 register set is almost the same as the AT86RF231 but there are a few fields that are slightly different. That is one of them. It’s best to leave it alone since it should match the datasheet.

    Akiba
    FreakLabs Open Source Wireless
    Twitter: @freaklabs
    Facebook: https://www.facebook.com/freaklabswireless

You must be logged in to reply to this topic.