Repost: How do I put the Freakduino to sleep and wake it up later?

Home Forums Hardware Freakduino Repost: How do I put the Freakduino to sleep and wake it up later?

This topic contains 1 reply, has 1 voice, and was last updated by  akiba September 11, 2017 at 2:33 pm.

  • Author
    Posts
  • #471

    akiba
    Keymaster

    To save power I need to put the entire Freakduino asleep (not just the radio), and then wake it up again when it’s time to take and transmit a measurement. Otherwise the batteries don’t last even a day.

    Please advise.

    Akiba
    FreakLabs Open Source Wireless
    Twitter: @freaklabs
    Facebook: https://www.facebook.com/freaklabswireless

  • #472

    akiba
    Keymaster

    Hi neverdie.
    I put together an example on how to go into deep sleep mode along with power measurements. You can see it here:
    Freakduino Wireless Walkthrough

    The part on low power mode is towards the bottom.
    Hope that helps.
    Akiba

    Akiba
    FreakLabs Open Source Wireless
    Twitter: @freaklabs
    Facebook: https://www.facebook.com/freaklabswireless

You must be logged in to reply to this topic.